Jump to Product:


Created by Brian Bodine, with over two decades of on-road racing experience, for the purpose of developing some great R/C racing accessories and tools. These products have been designed, then tested on the racing circuit and refined for the racer who wants that critical edge on the competition. Whether it is a part to improve a current design, a specialty tool to speed up adjustments or that hard to find hardware. Rest assured that it was developed: “because you need it and don’t know it”!


:: NEW!


New 11/9/2013, the Slapmaster Spring Chart for pan car springs. Finally a single chart that shows comparable measure between all of the different brand and rates of springs. This list will continue to evolve and be the standard in which we reference pan car springs.


The Slapmaster Caster Gauge measures your actual caster from the king pin without dismantling major parts of your front end.  Simply remove the front tire, e-clip and spring.  Slide the king pin into the hole on the gauge, set your car on the set up board to read your caster, compare to the other side for evenness.  The bottom hole in the A-Frame is for 12th scale, the upper hole is for F-1 and WGT.  Made from laser cut acrylic plastic etched to 14 degrees with a highly visible florescent pink needle in the back.  This caster tools is small enough to fit easily into tool boxes.  An excellent device that will detect crash damage or for simply comparing caster to other cars.  This gauge can only work on lower sprung king pin suspensions.




The Caster Gauge is specifically made for 1/8 inch or 3mm king pins and will not work on the opposite. They are sold as singles or in pairs.



#135 1/8" Caster Gauge-single; $12
#136 3mm Caster Gauge-single; $12
#137 1/8" Caster Gauge-pair; $22
#138 3mm Caster Gauge-pair; $22


HOW TO ORDER:

Use the contact form below to send Brian and email regarding what product you are interested in. It's quick, it's easy!
Your e-mail address:
Your message:
  Slapmaster Tools on RC TECH:

     — MS2.3 Discussion


— Slapmaster Tools. PO BOX 1782 Edmonds WA 98020 USA —
 
Copyright 2011 Slapmaster Tools.
No content may be reused without permission.
Web Design Provided by Studio462.
Website Issues? Contact the Webmaster.
Dealer and Customer Questions Contact Brian.
This site is under copyright. Slapmaster Tools is a registered Trademark.